CROSS TYPE TORQUE WRENCH
CROSS TYPE TORQUE WRENCH
Product Introduction
• DESCRIPTION:
- INNOVATIVE DESIGN FOR CONTROLLING TIGHTNESS OF WHEEL NUTS WHILE DOING TIRE CHANGE
- ONE SWITCH TO CHANGE DIRECTIONS TO RIGHT OR LEFT FOR TIGHTENING OR LOOSENING NUTS
- TIME-SAVING AND EFFORT-SAVING SPINNING MODE TO REPLACE NUTS
- FOR PERSONAL USE ONLY. NOT FOR INDUSTRIAL OR COMMERCIAL USE
• INSTRUCTIONS FOR USE
A. WORK WITH TORQUE WRENCH
1. TORQUE WRENCH MODE
1. TORQUE WRENCH MODE
1) PRESS LOCK/RELEASE BOTTOM 3, SLIDE HANDLE SHAFT 1 TO THE END OF CROSS SHAFT 2 AND LOCK
NOTE: THE TORQUE WRENCH FUNCTION IS ONLY AVAILABLE IN THIS MODE.
NOTE: THE TORQUE WRENCH FUNCTION IS ONLY AVAILABLE IN THIS MODE.
2) INSTALL PROPER SOCKET ONTO SQUARE HEAD 4 OF HANDLE SHAFT 1
2. SETTING THE TORQUE EASILY 1) PUSH SETTING / LOCKING KNOB 7 TO "UNLOCK".
2) DIAL SETTING/LOCKING KNOB 7 UNTIL DESIRED TORQUE SETTING IS DISPLAYED BY CURSOR (RED LINE) IN SCALE
WINDOW 5, GRADUATIONS ON THE SCALE IS ±4%
WINDOW 5, GRADUATIONS ON THE SCALE IS ±4%
3) PULL SLIGHTLY THEN RELEASE THE SETTING/LOCKING KNOB 7 WILL LOCK BY A TORQUE VALUE.
3. SPEED SPINNING MODE PLACE HANDLE SHAFT 1 IN THE MIDDLE OF CROSS SHAFT 2 TO INSERT AND NIP NUTS UP SPEEDILY
B. WORK AS A NUT LOOSENING TOOL
1. LEVERAGE POWER MODE FOR A POWER MODE AS CROSS WRENCH WHICH LOOSENS NUTS UP.
2. WARNING! DO NOT STEP DOWN ON THE SCALE OF CROSS SHAFT
3. WARNING! DO NOT PLACE FOOT IN THE SAME DIRECTION AS THE CROSS SHAFT. IT MUST BE STEPPED AT A VERTICAL ANGLE.
• STORAGE MODE
1. LEVERAGE POWER MODE FOR A POWER MODE AS CROSS WRENCH WHICH LOOSENS NUTS UP.
2. WARNING! DO NOT STEP DOWN ON THE SCALE OF CROSS SHAFT
3. WARNING! DO NOT PLACE FOOT IN THE SAME DIRECTION AS THE CROSS SHAFT. IT MUST BE STEPPED AT A VERTICAL ANGLE.
• STORAGE MODE
1) THIS TORQUE WRENCH IS DETACHABLE BY PRESS LOCK/RELEASE BOTTOM 3.
2) STORE THE TORQUE WRENCH IN THE PROTECTIVE PACKAGING. IT SHOULD BE STORED AT THE LOWEST TORQUE SETTING.
Contents:
- 1 PC 70~170 NM CROSS TYPE TORQUE WRENCH
- 3 PCS 1/2" DR. × 12.5 MM SQUARE SOCKET: 17, 19, 21 MM
- PACKING: BLOW CASE + LABEL
